| V1 Instrumentation -- Operation |
 |
|
The V1 series of instruments is configured or programmed by use of a single
pushbutton on the face of the display. Configuration is simply a matter of
cycling through the modes and cycling through the available
options/settings in each mode. The modes available vary on each
instrument. Consult the instrument detail sheet for more information
of the specific modes and settings available for specific
instruments. In general, there are 2 ways to press the button ... a
mode change, or a setting change. These are distinguished as
follows:
|
|
|
MODE: To change configuration mode, press and hold the button until the
display changes, then release. This should be at least 1 to 1.5
seconds.
|
|
|
SET: To change the setting within a configuration mode, press the button
and release it quickly, as if tapping a key on a keyboard. The
setting will change to the next available, as will be shown on the
display.
|
|
|
For instruments equipped with a peak feature on the bargraph, pressing
the button quickly during normal operation will clear the recorded
peak value.
|
|
|
For instruments equipped with an alarm, pressing the button quickly
during normal operation will silence the alarm buzzer, though the
display will continue to flash until the error condition has been
corrected.
|
|
|
This flowchart will make the explanation simpler...
|
|
 |
